Friday, August 6, 2010

Bottom of Boat Cut Out and Scarfed Areas Faired



Today, I cut out the bottom to the rough shape on the side and the front. I didn't cut out the stern area of the boat yet, because I have to figure out the best way to install the doublers that will go on the planing surfaces.
If you look close at the second photo, you can see the two scarfed areas that were glued together. It almost looks like one piece until you look closer.
I also faired the top side of the bottom scarfed areas with a mixture of epoxy and colloidal silica. This is supposed to be the easy stuff to sand once it cures. I will find out tomorrow.
2 hours

No comments:

Post a Comment