Monday, December 6, 2010

Quarter Rounds For The Sides; Transom Trimmed



Yesterday, I made the quarter round pieces (4 in all) that will attach to the bottom and the sides. They were cut to length, cut with a band saw every 1 inch or so to allow them to bend easier, drilled with a #54 drill bit approximately every four inches, and the appropriate length nail was put in each hole. Next they will be epoxied down to the bottom.
I also trimmed the transom sides to match up with the sides of the boat when they are installed, and sanded and smoothed down the transom to bottom joints fore and aft.
5 hours

No comments:

Post a Comment