Sunday, February 13, 2011

Rear Seat Vertical Epoxied; Front Seat Access Holes Cut



Today, after a long break for school and other projects, I cut the access holes in the front seat boxes and routed the edges with a1/2" roundover bit. I also filled most of the countersinked areas on the front seat boxes. A few more to finish it out next time.
First I sanded down both sides and then I trimmed the excess fiberglass and epoxy from the vertical rear seat piece and epoxied it into place at a 90 degree angle from the bottom. I also cleaned up each vent hole on this piece with a sanding wheel on a Dremel tool.

No comments:

Post a Comment