Monday, April 18, 2011

Rear Seat Taped, Beaver-tail Taped, Rear Seat Top Epoxied



Tonight, I epoxied 4" fiberglass tape for the rear seat part to the transom and hull sides. I also put 3" tape on the beaver-tail edges, as well as put another layer of slow epoxy on the rear seat top to smooth it out a little more.
3.5 hours
Posted by at

2 comments:

  1. RywilApril 18, 2011 at 9:37 PM

    Hey Todd,

    Great job! It's coming along very well.

    I have not started my build yet:( I found a great supplier in Buffalo for marine okoume plywood. I hope to have everything to get started in a couple weeks.

    Thanks again for keeping this blog going.

    Ryan

    ReplyDelete
  2. Todd WiechmanApril 19, 2011 at 9:05 PM

    Well, I am happy you are following this blog. At least someone is. Haha.
    I can't wait to see your project coming along.
    I was going to use okoume, but the shipping to get it here was more than the wood, so I used what I did.
    Keep in touch!!

    ReplyDelete

Subscribe to: Post Comments (Atom)